SORRY BUT UK MAINLAND DELIVERY ONLY.
Trial set consisting of 40g coarse sanding paste, 40g fine sanding paste and 40ml friction polish each.
This surface finishing set consists of two sanding pastes, coarse and fine, as well as the friction polish from König Holz & Harz. The coarse sanding paste sands the surface up to approx. grit 1000, the fine sanding paste sands the workpiece up to approx. grit 10000. The friction polish provides a shiny finish, is extremely robust, can be applied within minutes and dries immediately afterwards.
The paste and polish are equally suitable for hardwood, stabilised wood and also epoxy resin. The size of the work piece does not matter, just follow the steps listed below.
The polish is made from mineral oils, alcohols and natural resins. The pastes consist of natural oils, orange oil, natural waxes and mineral abrasives, for wood and resin finishing. All products are "Made in Germany".
Instruction grinding paste König Holz und Harz
Work on the lathe:
Sand to 400 grit, optional quick sanding primer.
Apply paste with a soft cloth (fast tearing, e.g. kitchen cloth) without running machine motor.
Then sand at a speed of 800 to 1000 rpm. Spread the paste until no residue is visible on the cloth.
Work on larger objects:
For larger surfaces, please take a small amount of grinding paste on a medium hard polishing sponge, Start at approx. 800-1000rpm. Sand until there is no more residue.
If the desired result is not yet achieved, repeat this process.
Now the surface is ready for its usual finish.
Instructions Sanding Paste König Holz und Harz fine
After using the sanding paste König Holz und Harz coarse or after pre-sanding to grain 1000.
Work on the lathe:
Apply paste with a soft cloth (fast tearing, for example kitchen cloth) without running machine motor.
Then at a speed of 800 to 1000 rpm. Spread the paste until no residue can be seen on the cloth.
Work on larger objects:
For larger surfaces, please take a small amount of grinding paste on a medium hard polishing sponge, Start at approx. 800-1000 rpm. Sand until there is no more residue.
If the desired result is not yet achieved, repeat this process.
Now the surface is ready for its usual finish.
Instructions for polishing:
After using our gloss sanding paste, apply a little polish to a soft, fast-tearing lint-free cloth (kitchen towel).
Machine at approx. 500 rpm. And rub over the surface of the workpiece with a lot of pressure until heat is generated.
As soon as it becomes dry, put a few drops of polish on the cloth again and repeat the process until the desired shine is achieved.
Subject to change without notice
Warning
Autoxidation in the oil-soaked cloth is accompanied by heat, which may cause spontaneous combustion of the oil-soaked cloth,
To avoid the possibility of fire, never stack the soaked cloths. Spread the cloth flat to dry. After drying, it can be disposed of in household waste.
Data are for guidance only