No results were found for the filter!
VM100 chuck M33x3.5 direct thread. VM100 chuck with standard jaws. Direct thread M33 x 3.5 The VM100 T - Bar Allen Key operated chuck allows for one handed tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the scroll. Keyed chucks cannot be...
VM100 chuck with thread inserts VM100 chuck with standard jaws. Inserts for 1 1/4 x 8, 1 1/2 x 6 and 1" x 8 available. The VM100 T - Bar Allen Key operated chuck allows for one handed tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the...
Vicmarc bowl jaws VM100 Vicmarc 385mm bowl jaw set. For bowls 385mm dia and smaller! The Vicmarc Bowl Jaws adjust to allow you to re-chuck different sized bowls for finishing the bottom, or do light clean-up work on the foot of the bowl. To mount the bowl, the...
Vm100, shark jaws Vicmarc VM100 chuck, 48mm, 55mm, 74mm & 88mm shark jaws. Shark Jaws have serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. They hold cylinder spigots much more safely than standard jaws. They are much...
Vicmarc VM100 dovetail jaws Designed for mounting bowls by expanding into a recess or clamping onto a spigot. The sizes indicated on the drawing are when the jaws form a perfect circle. VM100 chucks provide approx 38mm of expansion beyond these specified sizes.
Vicmarc Vm100 25mm pin jaws Vicmarc Vm100, 25mm pin jaws These jaws are used for expansion into small recesses and for firm holding of fine spindle work, such as earrings, chess pieces, etc. They are ideal for turning salt and pepper shakers. To turn very small...
Ray Key Collaborations Book Ray Key Collaborations Book. The book catalogues the collaboration project of part turned pieces from the late Ray Key’s workshop which were sent to turners around the world to finish in their own style. There are 128 pages with photos...
Gauge Master Center Finder Gauge Master Center Finder The Vicmarc - DNS Gauge Master was specially designed for woodturners to save time and money. This device incorporates angle checking and centre finding. This product is manufactured in Australia from injection...
worm screw This type of screw was first introduced by Vicmarc®. The thread type provides extra strength and is ideal for holding wood safely on the chuck. Standard is R/H If turning in reverse you need a L/H
Viewed