No results were found for the filter!
VM120 chuck M33 x 3.5 direct thread. Vicmarc VM120 chuck including standard jaws and direct M33 x 3.5 thread. The VM120 T - Bar Allen Key operated chuck allows for one handed tightening along with tremendous gripping power provided by the 5 to 1 ratio of the scroll. Keyed...
VM120 chuck 1 1/4 x 8 direct thread. Vicmarc VM120 chuck including standard jaws and direct 1 1/4 x 8 tpi thread. The VM120 T - Bar Allen Key operated chuck allows for one handed tightening along with tremendous gripping power provided by the 5 to 1 ratio of the scroll....
VM120 chuck with thread inserts VM120 chuck with standard jaws. Inserts for 1 1/2 x 6 and 1" x 8 available. The VM120 T - Bar Allen Key operated chuck allows for one-handed tightening along with tremendous gripping power provided by the 5 to 1 ratio of the scroll....
Vicmarc bowl jaws VM120 485mm Vicmarc 485mm bowl jaw set. For bowls 485mm dia and smaller! Fits only VM120 The Vicmarc Bowl Jaws adjust to allow you to re-chuck different sized bowls for finishing the bottom or do light clean-up work on the foot of the bowl. To mount...
Vicmarc Vm120 25mm pin jaws Vicmarc Vm120, 25mm pin jaws These jaws are used for expansion into small recesses and for firm holding of fine spindle work, such as earrings, chess pieces, etc. they are ideal for turning salt and pepper shakers. To turn very small...
VM120 dovetail jaws, 128mm,148mm & 173mm Vicmarc VM120 dovetail jaws. Dovetail Jaws have been designed for mounting bowls by expanding into a recess or clamping onto a spigot. The sizes indicated on the drawing are when the Jaws form a perfect circle. VM120 and VM150 chucks...
Vm120, shark jaws Vicmarc VM120 chuck, shark jaws. Shark Jaws have serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. they hold cylinder spigots much more safely than standard jaws. They are much easier and provide a...
Ray Key Collaborations Book Ray Key Collaborations Book. The book catalogues the collaboration project of part turned pieces from the late Ray Key’s workshop which were sent to turners around the world to finish in their own style. There are 128 pages with photos...
Face plate rings Vicmarc faceplate rings. These can be used instead of the traditional faceplate. They allow remounting of prepared blanks by mounting directly onto the chuck jaws. Faceplate Rings can also can be used for turning green wood which will...
Gauge Master Center Finder Gauge Master Center Finder The Vicmarc - DNS Gauge Master was specially designed for woodturners to save time and money. This device incorporates angle checking and centre finding. This product is manufactured in Australia from injection...
Viewed