Products from Vicmarc
No results were found for the filter!
VM120 dovetail jaws, 128mm,148mm & 173mm Vicmarc VM120 dovetail jaws. Dovetail Jaws have been designed for mounting bowls by expanding into a recess or clamping onto a spigot. The sizes indicated on the drawing are when the Jaws form a perfect circle. VM120 and VM150 chucks...
Vm120, shark jaws Vicmarc VM120 chuck, shark jaws. Shark Jaws have serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. they hold cylinder spigots much more safely than standard jaws. They are much easier and provide a...
150mm tool rest Vicmarc 150mm wide x 30mm stem tool rest. New ergonomic toolrest style Toolrest- Round 4140 high tensie steel bar welded on top for ease of use. (available for, VL240 & VL300 lathe models)
Vm100, shark jaws Vicmarc VM100 chuck, 48mm, 55mm, 74mm & 88mm shark jaws. Shark Jaws have serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. They hold cylinder spigots much more safely than standard jaws. They are much...
Vicmarc VM100 dovetail jaws Designed for mounting bowls by expanding into a recess or clamping onto a spigot. The sizes indicated on the drawing are when the jaws form a perfect circle. VM100 chucks provide approx 38mm of expansion beyond these specified sizes.
Vicmarc Vm100 25mm pin jaws Vicmarc Vm100, 25mm pin jaws Next stock due 15th Jan approx. These jaws are used for expansion into small recesses and for firm holding of fine spindle work, such as earrings, chess pieces, etc. They are ideal for turning salt and pepper...
vicmarc 100 pen jaw V00659 Pen Blank Jaw set comes as a set of 2 and are designed to clamp pen blank squares for drilling as shown below. These Jaws can clamp from 10mm square blanks up to 48mm square blanks.
Eccentric Chuck #3 NEXT STOCK DUE IN 24TH FEB 22 The Eccentric Chuck is designed and manufactured by Vicmarc Machinery and it expands the possibilities for off-centre turning. The main feature of this chuck is its infinitely variable axis setting capacity....
Face plate rings Vicmarc faceplate rings. These can be used instead of the traditional faceplate. They allow remounting of prepared blanks by mounting directly onto the chuck jaws. Faceplate Rings can also can be used for turning green wood which will...
Gauge Master Center Finder Gauge Master Center Finder The Vicmarc - DNS Gauge Master was specially designed for woodturners to save time and money. This device incorporates angle checking and center finding. This product is manufactured in Australia from injection...
Viewed