No results were found for the filter!
M33 x 3.5mm direct thread. The VM150 has two actions, one to quickly open and close the chuck as though it was a lever operated (fully opens within 3 revolutions), the other to tighten using the 'T' key as you would in a standard...
£345.00 *
Vicmarc 485mm bowl jaw set. For bowls 485mm dia and smaller! Fits only VM120 The Vicmarc Bowl Jaws adjust to allow you to re-chuck different sized bowls for finishing the bottom or do light clean-up work on the foot of the bowl. To mount...
£135.00 *
V00419-2 M33 x 3.5 3 in 1 Screw Face Plate This screw chuck has three alternative diameters of 50mm, 75mm and 100mm to give optimum support to any size of work. This Screw Face Plate comes complete with a woodscrew and has direct thread...
£120.00 *
Vicmarc VM120 chuck, shark jaws. Shark Jaws have serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. they hold cylinder spigots much more safely than standard jaws. They are much easier and provide a...
From £97.50 *
Vicmarc Vm120, 25mm pin jaws These jaws are used for expansion into small recesses and for firm holding of fine spindle work, such as earrings, chess pieces, etc. they are ideal for turning salt and pepper shakers. To turn very small...
£69.50 *
Vicmarc VM120 dovetail jaws. Dovetail Jaws have been designed for mounting bowls by expanding into a recess or clamping onto a spigot. The sizes indicated on the drawing are when the Jaws form a perfect circle. VM120 and VM150 chucks...
From £62.50 *
The safety ring prevents clamped workpieces from detaching from the spindle and falling off during operation, for example when turning in reverse or due to unexpected heavy braking. The ring fits all lathes with M33 spindle thread and...
£38.50 *
M33 x 3.5 female thread to 1" 1/2 x 6 TPI male. Made by Hopewoodturning. Gold Zinc plated
£22.50 *
M33 x 3.5 female thread to 1 1/4" x 8TPI male. Made by Hopewoodturning. Gold Zinc plated
£22.50 *
M33 x 3.5 female thread to |M33 x 3.5 male. Extends the spindle by 40mm. Made by Hopewoodturning.
£22.50 *
Bowl Jaw Clamp Set - Part No. - V00120 The Bowl Jaw Clamp Set is to be used in conjunction with the existing Bowl Jaw Grips and it allows for off centre turning as illustrated above. The Clamp Set includes two (2) clamp arms and all the...
£18.50 *